IA machine install: Difference between revisions
add ia install content |
add machine ia install |
||
| Line 1: | Line 1: | ||
Pre-requisites | == Pre-requisites == | ||
* Open machine cover | * Open machine cover | ||
* Type of LBPayLinker devices (Model NYJ or A1) | * Type of LBPayLinker devices (Model NYJ or A1) | ||
| Line 19: | Line 18: | ||
![[File:1000030589.png|center|thumb]]A1 | ![[File:1000030589.png|center|thumb]]A1 | ||
|} | |} | ||
2. Check LBPayLinker parts. | 2. Check LBPayLinker parts. | ||
| Line 52: | Line 50: | ||
(1) Coindrop power to board | (1) Coindrop power to board | ||
[[File:Ia coindrop cable.jpg|center|thumb|450x450px]] | [[File:Ia coindrop cable.jpg|center|thumb|450x450px]] | ||
(2) Coindrop signal to board | (2) Coindrop signal to board | ||
[[File:Ia signal cable.jpg|center|thumb|450x450px]] | [[File:Ia signal cable.jpg|center|thumb|450x450px]] | ||
7. Locate LBPayLinker machine wiring cable. | 7. Locate LBPayLinker machine wiring cable. | ||
| Line 62: | Line 58: | ||
8. Connect machine wiring cable | |||
8. Connect machine wiring cable IA type to coindrop - board cable. | |||
(1) Disconnect coindrop power to board cable and connect with LBPayLinker coindrop wiring cable. | (1) Disconnect coindrop power to board cable and connect with LBPayLinker coindrop wiring cable. | ||
(2) Disconnect coindrop signal to board cable and connect with LBPayLinker signal wiring cable. | (2) Disconnect coindrop signal to board cable and connect with LBPayLinker signal wiring cable. | ||
9. Connect machine power source connector to the board. | 9. Connect machine power source connector to the board. | ||
Revision as of 04:43, 19 April 2026
Pre-requisites
- Open machine cover
- Type of LBPayLinker devices (Model NYJ or A1)
- Type of LBPayLinker wiring cable (BC, IA or TOSEI)
IA Machine
Getting Started
- Make sure the LBPayLinker model Type. See picture.
 |
 |
|---|
2. Check LBPayLinker parts.
- For model NYJ31 - antenna and machine wiring cable
- For model A1 - interface cable and machine wiring cable
 |
 |
|---|
3. Connect the interface cable on the device.
 |
 |
|---|
4. Open IA machine cover.
5. Locate power connector and disconnect it to shutdown the machine.
6. Locate coindrop interface cable to machine board.
(1) Coindrop power to board
(2) Coindrop signal to board
7. Locate LBPayLinker machine wiring cable.
8. Connect machine wiring cable IA type to coindrop - board cable.
(1) Disconnect coindrop power to board cable and connect with LBPayLinker coindrop wiring cable.
(2) Disconnect coindrop signal to board cable and connect with LBPayLinker signal wiring cable.
9. Connect machine power source connector to the board.