View source for BC machine (washer and dryer) install

== Pre-requisites ==

* Open machine cover
* Type of LBPayLinker devices (Model NYJ or A1)
* Type of LBPayLinker wiring cable (BC, IA or TOSEI)

== BC Machine ==
This is the washer and dryer type of machine.[[File:Screenshot 20260417-171916 1.png|thumb|722x722px|BC Washer and Dryer|center]]


== Getting Started ==

# Make sure the LBPayLinker model Type. See picture.
{| class="wikitable"
|+Device Model
![[File:1000030570.png|thumb]]NYJ31
![[File:1000030589.png|thumb|340x340px]]A1
|}


2. Check LBPayLinker parts.
* For model NYJ31 - antenna and machine wiring cable
* For model A1 - interface cable and machine wiring cable

{| class="wikitable"
|+
![[File:Wiring bc nyj31.png|thumb]]NYJ31
![[File:WIRING BC A1.png|thumb|355x355px]]A1
|}


3. Connect the interface cable on the device.
[[File:Connect bc standard.jpg|center|thumb|631x631px|* for device NYJ31 connect wifi antenna cable and machine wiring cable as picture above.]]
[[File:Connect bc a1 touch.jpg|center|thumb|646x646px|* for device A1 connect interface cable and machine wiring cable as picture above]]



4. Open BC machine cover.
{| class="wikitable"
|+
![[File:Open bc 10kg.jpg|thumb]]open board cover
![[File:Open bc top cover.png|thumb]]open top cover
![[File:Wiring bc dryer.jpg|thumb]]open coindrop cover 
|}


5. Locate power connector and disconnect it to shutdown the machine.
[[File:Disconnect power bc.jpg|center|thumb]]


6. Locate coindrop interface cable to machine board.

(1) Coindrop power to board
(2) Coindrop signal to board[[File:Bc coindrop-board cable resize.jpg|center|thumb|506x506px]]


7. Locate LBPayLinker machine wiring cable.
[[File:Bc cable wiring.jpg|center|thumb|381x381px]]


8. Connect machine wiring cable BC type to coindrop - board cable.

(1) Disconnect coindrop power to board cable and loop with LBPayLinker wiring cable.
[[File:Bc power coindrop.jpg|center|thumb]]

(2) Disconnect coindrop signal to board cable and loop with LBPayLinker wiring cable. There are 2 signal pair, yellow-white and red-black. Use red-black signal pair.
[[File:Bc signal coindrop.jpg|center|thumb]]


9. Connect machine power source connector to the board.
[[File:Connect power source.jpg|center|thumb]]10. After the device done installation, next step is to configure the device. [[Configure device using admin app]]

== Installation video ==
Installation steps video. 

https://lbunlimitedwash.com/lbwiki/video/BC_Device_installation.mp4