BC machine (washer and dryer) install: Difference between revisions
No edit summary |
Add bc content |
||
| Line 28: | Line 28: | ||
![[File:WIRING BC A1.png|thumb|355x355px]]A1 | ![[File:WIRING BC A1.png|thumb|355x355px]]A1 | ||
|} | |} | ||
3. Connect the interface cable on the device. | 3. Connect the interface cable on the device. | ||
[[File:Connect bc nyj31.jpg|center|thumb|631x631px| | |||
* for device NYJ31 connect wifi antenna cable and machine wiring cable as picture above. | |||
]] | |||
[[File:Connect bc a1.jpg|center|thumb|646x646px| | |||
* for device A1 connect interface cable and machine wiring cable as picture above | |||
]] | |||
Revision as of 00:35, 18 April 2026
Pre-requisites
- Open machine cover
- Type of LBPayLinker devices (Model NYJ or A1)
- Type of LBPayLinker wiring cable (BC, IA or TOSEI)
BC Machine
This is the washer and dryer type of machine.
Getting Started
- Make sure the LBPayLinker model Type. See picture.
 |
 |
|---|
2. Check LBPayLinker parts.
- For model NYJ31 - antenna and machine wiring cable
- For model A1 - interface cable and machine wiring cable
 |
 |
|---|
3. Connect the interface cable on the device.
4. Open BC machine cover.
 |
 |
 |
|---|
5. Locate power connector and disconnect it to shutdown the machine.
5. Locate coindrop interface cable to machine board.
6. Disconnect coindrop power to board cable and loop with LBPayLinker wiring cable.
7. Disconnect coindrop signal to board cable and loop with LBPayLinker wiring cable. There are 2 signal pair, yellow-white and red-black. Use yellow-white signal pair.